In General

Alcohol-dispersion of silicon compounds, to protect and restore glass and generally non-absorbent surfaces.

It preserves the original appearance of the surface and allows easy cleaning, without using chemical cleaners.

Moreover, it prevents the entry of moisture, with the known consequences, as well as the forming of mold greenery and microorganisms.


Indented Use

The product is suitable for:

  • glazed tiles
  • SanitaryEN maxilaraki easy cgl
  • Sinks
  • Batteries (water mixers, taps)
  • Glass surfaces (windows)
  • Non-absorbent surfaces
  • Plexi glass
  • Inox
  • Aluminum
  • Panel P / V systems
  • Solar Panels



  • Appearance:            Transparent
  • Odour:                     ethyl alcohol (alcohol)
  • Density:                   0.8 kg/lt.



On average 50 ml per square meter(m2) depending on the porosity and the kind of the substrate.


Available in packages of 200 ml and 1 lt. as well as in larger cans upon request.

Shelf life and storage

Since the product is not exposed to direct sunlight and it is stored at temperatures between 5 and 35 degrees Celsius, it can be retained in its unopened packaging for 12 months since the production date.



  • The surfaces to be treated must be clean from dust, grease and various residues. So carefully cleaning is recommended. Common cleaning products can be used with following very good rinsing. The surface must be dry before applying the product.
  • The most appropriate method of application on large surfaces is spraying with High Volume Low-Pressure equipment(HVLP). However, conventional methods such as spray or dipping can be used. Always should follow rubbing with a soft clean cloth to spread the material evenly. The equipment must be clean and dry without any residual material from a previous use. The final result does not differ in relation to the method of application, but in case of mechanical spray gun, there are savings on material and time, as well.
  • At first, apply sufficient quantity of material, so that can be spread with a cloth. The process is repeated until the entire surface covered. The product required for the second apply (optional) which could be done after the first dry is significantly less.
  • It is recommended to do a small test patch prior to application (e.g. in a corner) to check the compatibility with the substrate.
  • During application, the temperature should range between 5 and 40 degrees Celsius.



  • After applying the product a possible change in appearance and texture of the surface will be negligible.
  • Breathability of the substrate is maintained. This means that the abilility of the original surface to transpire is not affected. Thus, any possible trapped moisture is not prevented from exiting.
  • Since the coatings are resistant to UV radiation, they are guaranteed for long periods, even for longer than 5 years.


The products of  NanoWin Ltd. are registered in the General Laboratory of the Greek State and in addition, they have undergone inspection & testing by:

    * Ministry of Infrastructure, Transport and Networks   (formerly Ministry of Enviroment,Physical Plannig and Public Works )    (By the Directories of Technical Material Testing)





More in this category: « rep Wood easy BATH »
©2011-2012 M&F Nano Ltd
This site was designed and hosted by Enterprise Software & Consulting